
Our LED downlight installation service in Talke fits slim, low-energy downlights in kitchens, bathrooms, living rooms and extensions. We choose fire-rated and IP-rated fittings where they are needed.

Where a ceiling separates one floor from another, cutting holes for downlights can weaken its fire resistance. Fire-rated downlights seal the hole if a fire starts below. We fit them wherever building regulations call for them, such as ceilings under bedrooms.
Bathrooms are split into zones around the bath and shower. A downlight above the shower must have a high IP rating so water cannot get in. We check each position against the zones and fit the right fitting for each one, not just the same light throughout.
Too few downlights leave dark patches, and too many make a room feel like a shop. We space them to light the room evenly and point them where you work. Warm white suits living rooms and bedrooms, while slightly cooler light works well in kitchens and bathrooms.
We look at the room, the ceiling and what is above it, then mark out the positions with you. We check the existing lighting circuit and whether any ceilings need fire-rated or insulation-covered fittings. You then receive a free quote for the fittings and the work.
On the day, we cut neat round holes, run the cables through the ceiling space and connect each downlight. Any old fitting holes are filled ready for painting. We test the circuit, check the lights from every switch and leave a certificate for the work.
Tell us what you need or what has gone wrong. We aim to respond the same day across Stoke-on-Trent.
We look at the job, explain what needs doing and give you a free quote before any work starts.
We finish the job, test everything we have worked on and hand over the certificate for your records.
It depends on the size and shape of the room and the brightness of the fittings. As a rough guide, downlights are often spaced about a metre to a metre and a half apart. We work out the layout for your kitchen and put extra light over worktops and the hob.
Yes, as long as each fitting has the right IP rating for its zone. Directly above a bath or shower needs a higher rating than further away. The circuit also needs RCD protection. We check every position against the bathroom zones before we fit anything.
LED downlights run much cooler than old halogen ones, but they still need the right fitting where loft insulation covers them. Some fittings are made to be covered by insulation, and others need space around them. We choose the right type for your ceiling.
Yes. In many homes around Stoke-on-Trent, old halogen spotlights can be swapped for LED fittings that use far less energy and give off less heat. We check the existing fittings and transformers, replace them with LED and fire-rated fittings where needed, and test the circuit.
We fit LED downlights in Talke and the nearby towns and villages. Select your area below.
Tell us which rooms you want downlights in, and we'll mark out a layout with you and quote for free.